common_cells

// Copyright 2018 ETH Zurich and University of Bologna.
// Copyright and related rights are licensed under the Solderpad Hardware
// License, Version 0.51 (the "License"); you may not use this file except in
// compliance with the License. You may obtain a copy of the License at
// http://solderpad.org/licenses/SHL-0.51. Unless required by applicable law
// or agreed to in writing, software, hardware and materials distributed under
// this License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR
// CONDITIONS OF ANY KIND, either express or implied. See the License for the
// specific language governing permissions and limitations under the License.

// Antonio Pullini <pullinia@iis.ee.ethz.ch>

module pulp_sync_wedge #(
    parameter int unsigned STAGES = 2
) (
    input  logic clk_i,
    input  logic rstn_i,
    input  logic en_i,
    input  logic serial_i,
    output logic r_edge_o,
    output logic f_edge_o,
    output logic serial_o
);
    logic clk;
    logic serial, serial_q;

    assign serial_o =  serial_q;
    assign f_edge_o = ~serial &  serial_q;
    assign r_edge_o =  serial & ~serial_q;

    pulp_sync #(
        .STAGES(STAGES)
    ) i_pulp_sync (
        .clk_i,
        .rstn_i,
        .serial_i,
        .serial_o ( serial )
    );

    pulp_clock_gating i_pulp_clock_gating (
        .clk_i,
        .en_i,
        .test_en_i ( 1'b0    ),
        .clk_o     ( clk )
    );

    always_ff @(posedge clk, negedge rstn_i) begin
        if (!rstn_i) begin
            serial_q <= 1'b0;
        end else begin
            serial_q <= serial;
        end
    end

endmodule