Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
// Copyright 2018 ETH Zurich and University of Bologna.
// Copyright and related rights are licensed under the Solderpad Hardware
// License, Version 0.51 (the "License"); you may not use this file except in
// compliance with the License. You may obtain a copy of the License at
// http://solderpad.org/licenses/SHL-0.51. Unless required by applicable law
// or agreed to in writing, software, hardware and materials distributed under
// this License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR
// CONDITIONS OF ANY KIND, either express or implied. See the License for the
// specific language governing permissions and limitations under the License.
// Antonio Pullini <pullinia@iis.ee.ethz.ch>
module edge_propagator (
input logic clk_tx_i,
input logic rstn_tx_i,
input logic edge_i,
input logic clk_rx_i,
input logic rstn_rx_i,
output logic edge_o
);
logic [1:0] sync_a;
logic sync_b;
logic r_input_reg;
logic s_input_reg_next;
assign s_input_reg_next = edge_i | (r_input_reg & (~sync_a[0]));
always @(negedge rstn_tx_i or posedge clk_tx_i) begin
if (~rstn_tx_i) begin
r_input_reg <= 1'b0;
sync_a <= 2'b00;
end else begin
r_input_reg <= s_input_reg_next;
sync_a <= {sync_b,sync_a[1]};
end
end
pulp_sync_wedge i_sync_clkb (
.clk_i ( clk_rx_i ),
.rstn_i ( rstn_rx_i ),
.en_i ( 1'b1 ),
.serial_i ( r_input_reg ),
.r_edge_o ( edge_o ),
.f_edge_o ( ),
.serial_o ( sync_b )
);
endmodule
5a7cab001This file is pinned to the selected release. Download the original to open it in your design tool.