Loading files
## V0 Display Assembly Guide: ##
This is **NOT** an instruction manual. While the components here were picked as they were easy to solder with an iron it is not an "easy/beginner" project.
----
### Assembly Guide
- For initial testing install:
- MCU (U2)
- MCU Caps (C3,C4)
- Voltage Regulator (U1)
- Regulator Caps (C1, C2)
- USB port (If you are using it), or USB header
- Verify there are no shorts between 5V and ground (On the USB header) as well as 3V and ground (Across C2).
- If there are shorts, examine the components for solder bridges and recheck.
- If there are no shorts, continue.
- Plug board into Pi and follow the [Setup guide](Setup_and_Flashing_Guide.md) until step 5 to verify that the MCU is operational and detected.
- Finish the SMD assembly by installing the:
- Neopixel buffer (U3)
- Other resistors (R1-R3)
- Neopixel (On front of board)
- Install Headers:
- Boot Jumper (J4)
- OpenOCD (J3)
- *optional* GPIO (GPIO)
- *optional* USB (J7)
- *optional* Neopixel Data Out(J8)
- Install encoder or 4 tactile switches for navigation
- Install 6mm x 6mm x 4.3mm for Kill Switch (SW6) and Reset Switch (SW5)
-Needs to be 4.3mm tall for the stock button lever to work.
- Finally, install the 1.3" OLED screen with the printed spacer under the bottom to keep it flat.
- *NOTE* once this is installed it is difficult to access other parts without removing the display,
1dbb83ac8This file is pinned to the selected release. Download the original to open it in your design tool.