Loading files
9e1b4e7c1This file is pinned to the selected release. Download the original to open it in your design tool.
## V0 Display Assembly Guide: ##
This is **NOT** an instruction manual. While the components here were picked as they were easy to solder with an iron it is not an "easy/beginner" project.
----
### Assembly Guide
- For initial testing install:
- MCU (U2)
- MCU Caps (C3,C4)
- Voltage Regulator (U1)
- Regulator Caps (C1, C2)
- USB port (If you are using it), or USB header
- Verify there are no shorts between 5V and ground (On the USB header) as well as 3V and ground (Across C2).
- If there are shorts, examine the components for solder bridges and recheck.
- If there are no shorts, continue.
- Plug board into Pi and follow the [Setup guide](Setup_and_Flashing_Guide.md) until step 5 to verify that the MCU is operational and detected.
- Finish the SMD assembly by installing the:
- Neopixel buffer (U3)
- Other resistors (R1-R3)
- Neopixel (On front of board)
- Install Headers:
- Boot Jumper (J4)
- OpenOCD (J3)
- *optional* GPIO (GPIO)
- *optional* USB (J7)
- *optional* Neopixel Data Out(J8)
- Install encoder or 4 tactile switches for navigation
- Install 6mm x 6mm x 4.3mm for Kill Switch (SW6) and Reset Switch (SW5)
-Needs to be 4.3mm tall for the stock button lever to work.
- Finally, install the 1.3" OLED screen with the printed spacer under the bottom to keep it flat.
- *NOTE* once this is installed it is difficult to access other parts without removing the display,