Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
/*
TinyMIDI2CV
Copyright 2023-2024 Beau Sterling (Aether Soundlab)
Hardware config is based on DIY Good Ol’ MIDI to CV by Jan Ostman:
(*) All in the spirit of open-source and open-hardware
Janost 2019 Sweden
The goMIDI2CV interface
http://blog.dspsynth.eu/diy-good-ol-midi-to-cv/
Copyright 2019 DSP Synthesizers Sweden.
This file is part of TinyMIDI2CV.
TinyMIDI2CV is free software: you can redistribute it and/or modify it
under the terms of the GNU General Public License as published by the Free
Software Foundation, either version 3 of the License, or (at your option)
any later version.
TinyMIDI2CV is distributed in the hope that it will be useful, but WITHOUT
ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
more details.
You should have received a copy of the GNU General Public License along with
TinyMIDI2CV. If not, see <https://www.gnu.org/licenses/>.
*/
// Set Fuses to E1 DD FE for PLLCLK 16MHz
#include <Arduino.h>
// #include <avr/io.h>
// #include <avr/pgmspace.h>
#include "global.h"
#include "midi.h"
#include "gate.h"
#include "cv2.h"
void setup()
{
// Enable 64 MHz PLL and use as source for Timer1
PLLCSR = 1 << PCKE | 1 << PLLE;
// Setup the USI
USICR = 0; // Disable USI.
GIFR = 1 << PCIF; // Clear pin change interrupt flag.
GIMSK |= 1 << PCIE; // Enable pin change interrupts
PCMSK |= 1 << PCINT0; // Enable pin change on pin 0
// Set up Timer/Counter1 for PWM output
TIMSK = 0; // Timer interrupts OFF
TCCR1 = 1 << PWM1A | 2 << COM1A0 | 1 << CS10; // PWM A, clear on match, 1:1 prescale
OCR1A = 0; // Set initial Pitch to C2
OCR1B = 127; // Set initial CV to center (pitchbend center)
OCR1C = 239; // Set count to semi tones
GTCCR = 0;
GTCCR = 1 << PWM1B | 2 << COM1B0; // PWM B, clear on match
// Setup GPIO
pinMode(USI_PIN, INPUT); // Enable USI input pin
pinMode(NOTE_CV_PIN, OUTPUT); // Enable PWM output pin
pinMode(GATE_CV_PIN, OUTPUT); // Enable Gate output pin
pinMode(MISC_CV_PIN, OUTPUT); // Enable CV2 PWM output pin
sendGate(GATE_CLOSED); // Set initial Gate to LOW;
setCV2Mode(CV2_PITCH_BEND); // Set initial CV2 source to Pitchbend
}
void loop()
{
// do nothing, everything happens via interrupts
}
4b95d5c7bThis file is pinned to the selected release. Download the original to open it in your design tool.