stmbl

HAL_COMP(hv);

HAL_PIN(a) = 0.0;
HAL_PIN(b) = 0.0;

HAL_PIN(enable) = 0.0;
HAL_PIN(error) = 0.0;

HAL_PIN(dc_cur) = 0.0;
HAL_PIN(dc_volt) = 0.0;
HAL_PIN(ac_volt) = 0.0;
HAL_PIN(hv_temp) = 0.0;
HAL_PIN(power) = 0.0;
HAL_PIN(dc_cur_sim) = 0.0;
HAL_PIN(iq) = 0.0;

HAL_PIN(rev) = 0.0;


#ifdef TROLLER
HAL_PIN(iu) = 0.0;
HAL_PIN(iv) = 0.0;
HAL_PIN(iw) = 0.0;
#endif

MEM(volatile packet_to_hv_t packet_to_hv);
MEM(volatile packet_from_hv_t packet_from_hv);


INIT(
   //setup uart to f1. uses DMA to transfer to_hv struct.
   GPIO_InitTypeDef GPIO_InitStruct;
   USART_InitTypeDef USART_InitStruct;
   UART_DRV_CLOCK_COMMAND(UART_DRV_RCC, ENABLE);

   //USART TX
   GPIO_PinAFConfig(UART_DRV_TX_PORT, UART_DRV_TX_PIN_SOURCE, UART_DRV_TX_AF_SOURCE);
   GPIO_InitStruct.GPIO_Pin = UART_DRV_TX_PIN;
   GPIO_InitStruct.GPIO_Mode = GPIO_Mode_AF;
   GPIO_InitStruct.GPIO_Speed = GPIO_Speed_50MHz;
   GPIO_InitStruct.GPIO_OType = GPIO_OType_PP;
   GPIO_InitStruct.GPIO_PuPd = GPIO_PuPd_UP ;
   GPIO_Init(UART_DRV_TX_PORT, &GPIO_InitStruct);

   //USART RX
   GPIO_PinAFConfig(UART_DRV_RX_PORT, UART_DRV_RX_PIN_SOURCE, UART_DRV_RX_AF_SOURCE);
   GPIO_InitStruct.GPIO_Pin = UART_DRV_RX_PIN;
   GPIO_Init(UART_DRV_RX_PORT, &GPIO_InitStruct);

   USART_InitStruct.USART_BaudRate = DATABAUD;
   USART_InitStruct.USART_WordLength = USART_WordLength_8b;
   USART_InitStruct.USART_StopBits = USART_StopBits_1;
   USART_InitStruct.USART_Parity = USART_Parity_No;
   USART_InitStruct.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
   USART_InitStruct.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
   USART_Init(UART_DRV, &USART_InitStruct);

   /* Enable the USART */
   USART_Cmd(UART_DRV, ENABLE);

   // DMA-Disable
   DMA_Cmd(UART_DRV_TX_DMA, DISABLE);
   DMA_DeInit(UART_DRV_TX_DMA);

   // DMA2-Config
   DMA_InitStructure.DMA_Channel = UART_DRV_TX_DMA_CHAN;
   DMA_InitStructure.DMA_PeripheralBaseAddr = (uint32_t)&(UART_DRV->DR);
   DMA_InitStructure.DMA_Memory0BaseAddr = (uint32_t)&packet_to_hv;
   DMA_InitStructure.DMA_DIR = DMA_DIR_MemoryToPeripheral;
   DMA_InitStructure.DMA_BufferSize = sizeof(packet_to_hv_t);
   DMA_InitStructure.DMA_PeripheralInc = DMA_PeripheralInc_Disable;
   DMA_InitStructure.DMA_MemoryInc = DMA_MemoryInc_Enable;
   DMA_InitStructure.DMA_PeripheralDataSize = DMA_PeripheralDataSize_Byte;
   DMA_InitStructure.DMA_MemoryDataSize = DMA_PeripheralDataSize_Byte;
   DMA_InitStructure.DMA_Mode = DMA_Mode_Normal;
   DMA_InitStructure.DMA_Priority = DMA_Priority_High;
   DMA_InitStructure.DMA_FIFOMode = DMA_FIFOMode_Disable;
   DMA_InitStructure.DMA_FIFOThreshold = DMA_FIFOThreshold_HalfFull;
   DMA_InitStructure.DMA_MemoryBurst = DMA_MemoryBurst_Single;
   DMA_InitStructure.DMA_PeripheralBurst = DMA_PeripheralBurst_Single;
   DMA_Init(UART_DRV_TX_DMA, &DMA_InitStructure);

   //DMA_Cmd(UART_DRV_TX_DMA, ENABLE);

   USART_DMACmd(UART_DRV, USART_DMAReq_Tx, ENABLE);


  // DMA-Disable
  DMA_Cmd(UART_DRV_RX_DMA, DISABLE);
  DMA_DeInit(UART_DRV_RX_DMA);

  // DMA2-Config
  DMA_InitStructure.DMA_Channel = UART_DRV_RX_DMA_CHAN;
  DMA_InitStructure.DMA_PeripheralBaseAddr = (uint32_t)&(UART_DRV->DR);
  DMA_InitStructure.DMA_Memory0BaseAddr = (uint32_t)&packet_from_hv;
  DMA_InitStructure.DMA_DIR = DMA_DIR_PeripheralToMemory;
  DMA_InitStructure.DMA_BufferSize = sizeof(packet_from_hv_t);
  DMA_InitStructure.DMA_PeripheralInc = DMA_PeripheralInc_Disable;
  DMA_InitStructure.DMA_MemoryInc = DMA_MemoryInc_Enable;
  DMA_InitStructure.DMA_PeripheralDataSize = DMA_PeripheralDataSize_Byte;
  DMA_InitStructure.DMA_MemoryDataSize = DMA_PeripheralDataSize_Byte;
  DMA_InitStructure.DMA_Mode = DMA_Mode_Normal;
  DMA_InitStructure.DMA_Priority = DMA_Priority_High;
  DMA_InitStructure.DMA_FIFOMode = DMA_FIFOMode_Disable;
  DMA_InitStructure.DMA_FIFOThreshold = DMA_FIFOThreshold_HalfFull;
  DMA_InitStructure.DMA_MemoryBurst = DMA_MemoryBurst_Single;
  DMA_InitStructure.DMA_PeripheralBurst = DMA_PeripheralBurst_Single;
  DMA_Init(UART_DRV_RX_DMA, &DMA_InitStructure);


  USART_DMACmd(UART_DRV, USART_DMAReq_Rx, ENABLE);

  packet_to_hv.head.start = 255;
  packet_to_hv.head.key = 0;
  packet_from_hv.head.start = 0;
  packet_from_hv.head.key = 0;
)

RT(
   float e = PIN(enable);

   if(packet_from_hv.head.start == 255){
      unbuff_packet((packet_header_t*)&packet_from_hv, sizeof(from_hv_t));
      packet_from_hv.head.start = 0;
      PIN(dc_cur) = TOFLOAT(packet_from_hv.data.dc_cur)*0.5 + PIN(dc_cur)*0.5;
      PIN(dc_volt) = TOFLOAT(packet_from_hv.data.dc_volt);
      PIN(ac_volt) = PIN(dc_volt) / 2.0 * 0.95 * 1.15;
      PIN(hv_temp) = TOFLOAT(packet_from_hv.data.hv_temp);
      #ifdef TROLLER
      PIN(iu) = TOFLOAT(packet_from_hv.data.a);
      PIN(iv) = TOFLOAT(packet_from_hv.data.b);
      PIN(iw) = TOFLOAT(packet_from_hv.data.c);
      #endif
      PIN(error) = 0.0;
   }
   else{
      PIN(error) = 1.0;
   }

   float a = PIN(a);
   float b = PIN(b);

   if(PIN(rev) > 0.0){
      b *= -1.0;
   }

  if(e > 0.0){
    packet_to_hv.data.a = TOFIXED(a);
    packet_to_hv.data.b = TOFIXED(b);
  }
  else{
    packet_to_hv.data.a = 0;
    packet_to_hv.data.b = 0;
  }
  buff_packet((packet_header_t*)&packet_to_hv, sizeof(to_hv_t));

  //start DMA TX transfer
  DMA_Cmd(UART_DRV_TX_DMA, DISABLE);
  DMA_ClearFlag(UART_DRV_TX_DMA, UART_DRV_TX_DMA_TCIF);
  DMA_Cmd(UART_DRV_TX_DMA, ENABLE);

  //start DMA RX transfer
  DMA_Cmd(UART_DRV_RX_DMA, DISABLE);
  DMA_ClearFlag(UART_DRV_RX_DMA, UART_DRV_RX_DMA_TCIF);
  DMA_Cmd(UART_DRV_RX_DMA, ENABLE);

  PIN(power) = PIN(dc_cur) * PIN(dc_volt);
  if(PIN(ac_volt) > 0.0){
    PIN(dc_cur_sim) = PIN(iq) / PIN(ac_volt) * sqrtf(a*a + b*b)*0.5 + PIN(dc_cur_sim)*0.5;
  }
);

ENDCOMP;