common_cells

// Copyright 2018 ETH Zurich and University of Bologna.
// Copyright and related rights are licensed under the Solderpad Hardware
// License, Version 0.51 (the "License"); you may not use this file except in
// compliance with the License. You may obtain a copy of the License at
// http://solderpad.org/licenses/SHL-0.51. Unless required by applicable law
// or agreed to in writing, software, hardware and materials distributed under
// this License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR
// CONDITIONS OF ANY KIND, either express or implied. See the License for the
// specific language governing permissions and limitations under the License.

// Fall-through register with a simple stream-like ready/valid handshake.
// This register does not cut combinatorial paths on any signals: in case the module at its output
// is ready to accept data within the same clock cycle, they are forwarded. Use this module to get a
// 'default ready' behavior towards the input.
module fall_through_register #(
    parameter type T = logic  // Vivado requires a default value for type parameters.
) (
    input  logic    clk_i,          // Clock
    input  logic    rst_ni,         // Asynchronous active-low reset
    input  logic    clr_i,          // Synchronous clear
    input  logic    testmode_i,     // Test mode to bypass clock gating
    // Input port
    input  logic    valid_i,
    output logic    ready_o,
    input  T        data_i,
    // Output port
    output logic    valid_o,
    input  logic    ready_i,
    output T        data_o
);

    logic   fifo_empty,
            fifo_full;

    fifo_v3 #(
        .FALL_THROUGH   (1'b1),
        .DEPTH          (1),
        .dtype          (T)
    ) i_fifo (
        .clk_i          (clk_i),
        .rst_ni         (rst_ni),
        .flush_i        (clr_i),
        .testmode_i     (testmode_i),
        .full_o         (fifo_full),
        .empty_o        (fifo_empty),
        .usage_o        (),
        .data_i         (data_i),
        .push_i         (valid_i & ~fifo_full),
        .data_o         (data_o),
        .pop_i          (ready_i & ~fifo_empty)
    );

    assign ready_o = ~fifo_full;
    assign valid_o = ~fifo_empty;

endmodule