ZX81 External 16K/32K RAM interface with WRX hi-res support
Loading README and project media…
Simple and compact external RAM interface for the ZX81 with WRX compability. First version is a 16K module and can be used on ZX80 and Lambda 8300 or simlar as well. The interface is made using THT components, making it easy for everyone to make.
The interface has been tested with the following 32K SRAM chips, all running Beamrider perfectly.
It turns out that v1.1 does not work together with the zx81-external-eprom interface, due to issues with the ROMCS line that can be fixed with a diode on the ROMCS line. The schema has been updated with this fix, but if you already have a v1.1 PCB it's easy to do the fix.
And now it runs fine with the zx81-external-eprom interface as well.
BOM for v1.2 (ROMCS fix)
Most version for internal 32K RAM puts the extra 16K at the top, 48 to 64K - but this is not what most 32K program expects. The 32K programs I have found expect the 32K from 16K, which requires some extra logic - another issue with this configuration is that normaly the ROM is mirrored between 32 and 48K, which means the ROM has to be disabled when the ZX81 access this part of the memory. I also decided to change the diodes from 1N4148 to BAT85 as suggested in general for this type of usage.
A little prototyping based on the v1.0 board - and yes, 32K from adress 16384 is all good here tested with Beamrider that require 32K and WRX :-)
This test program examines the memory configuration and reports this, 32K ram starting from address 0x4000 :-)
32K Programs NOT working - as they require internal modification in order to run M/C above 32K area.
BOM for v1.1 (32K, continously from adress 16384)
The interface for now is only using 16K from the 62256 memory chip, using the other half 16K might be added on later version. I might also consider making a SMD version, making it even smaller in size :-)
| SCHEMA | PCB |
|---|---|
The PCB arrived, so I populated it with some components (all written on the silkscreen).
BOM for v1.0 (16K only)
NOTE: WRX hi-res, to get full support for hi-res WRX a cercamic capacitor is needed between PIN 20 (CS) and GND. In this build with a KM62256ALP-10 a 1,2nF ceramic capacitor should be fitted.
The value for the capacitor for different 62256 SRAM chips tested with STARFIGHT