Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
# Step 5 : Server's assembly
This step is for assembling the server's pcb to the printed parts and finishing the server's box.
1. Take the server's base and 4 threaded inserts, place them in the holes and push them inside with a soldering iron (watch [this video](https://www.youtube.com/watch?v=KqSmCHr4fdA) if you need help)
2. Take the server's lid, a slide switch, 2 screws and screw the switch.
3. Now take the 2 led rings and glue them in the slots with the glue gun, make sure the pins are accessible in the hole on the back of the lid.
4. Take the light diffusers and glue them on top of the rings
5. Take the server's pcb and the buzzer and solder the buzzer
6. Take 5 wires, 1x9cm and 4x5cm
take the server's lid
And solder them like this, the **DO** of the first ring must be connected to the **DI** of the second one
7. Take 3x8cm wires and 2 heat shrink tubes
Place the heat shrink tubes like this
Solder the matching wires
Solder the new wires at the connection and place the heat shrink tubes around the exposed part and heat them
8. Take the pcb and the lid
Solder the wires to the pcb
9. Take a 9cm wire and solder it to the middle pin of the slide switch and to the **VCC** of the pcb
10. Take the base, the lid and 2 screws and screw the pcb
11. Take the AA battery holder and cut it's wires like this
Take the glue gun and glue the AA battery holder and the buzzer
12. Solder the red wire of the AA battery holder to the left side pin of the slide switch
13. Take the 3 AA batteries and place them in the holder
14. Take the M3 screws and close the lid
And you're done ! Now you should have all the three parts
d2e287f7dThis file is pinned to the selected release. Download the original to open it in your design tool.