stmbl

//stmbl
#define AREF 3.338  // analog reference voltage
#define HV_EN_PIN GPIO_PIN_15
#define HV_EN_PORT GPIOA
//fault pin cannot be used, as it is sometimes reset by the iram due to 15v ripple
#define HV_FAULT_PIN GPIO_PIN_7
#define HV_FAULT_PORT GPIOB
#define HV_FAULT_POLARITY GPIO_PIN_RESET
#define LED_PIN GPIO_PIN_8
#define LED_PORT GPIOA
#define BRK_PIN GPIO_PIN_2
#define BRK_PORT GPIOB

#define VDIVUP 249000.0 * 2.0  //HV div pullup R1,R12
#define VDIVDOWN 3900.0        //HV div pulldown R2,R9
#define SHUNT 0.003            //shunt
#define SHUNT_PULLUP 15000.0
#define SHUNT_SERIE 470.0

#define PWM_U TIM8->CCR3
#define PWM_V TIM8->CCR2
#define PWM_W TIM8->CCR1

#define PWM_DEADTIME 0
//#define PWM_DEADTIME 29 // 1/144e6 * 29 = 201ns
#define PWM_RES 4800

#define ABS_MAX_TEMP 100.0
#define ABS_MAX_VOLT 410.0
#define ABS_MAX_CURRENT 30.0

//io board
//#define USB_CONNECT_PIN GPIO_PIN_15
//#define USB_CONNECT_PORT GPIOB

/*
//otter
//TODO: swap v,w cur feedback
#define PWM_INVERT
#define AREF 3.3// analog reference voltage

#define VDIVUP 56000.0//HV div pullup R1,R12
#define VDIVDOWN 2000.0//HV div pulldown R2,R9
#define SHUNT 0.003//shunt
#define SHUNT_PULLUP 5100.0
#define SHUNT_SERIE 100.0

#define LED_Pin GPIO_PIN_0
#define LED_GPIO_Port GPIOA

#define PWM_U TIM8->CCR1
#define PWM_V TIM8->CCR2
#define PWM_W TIM8->CCR3
 
//ottercontrol
#define USB_DISCONNECT_PIN GPIO_PIN_13
#define USB_DISCONNECT_PORT GPIOC

#define PWM_DEADTIME 50
*/