Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
bbabecca6This file is pinned to the selected release. Download the original to open it in your design tool.
`timescale 1ns / 1ps
module top(
input wire clk100mhz,
input wire rst,
input wire uart_rx_i,
output wire uart_tx_o,
output wire[15:0] led
);
// Hold the SoC in reset for a short time after FPGA configuration. The
// teaching CPU uses a mixture of synchronous and asynchronous reset
// registers, so relying only on a human button press can leave pipeline
// registers in an implementation-dependent state immediately after
// programming.
reg[19:0] por_count = 20'd0;
reg por_rst = 1'b1;
always @(posedge clk100mhz or posedge rst) begin
if (rst) begin
por_count <= 20'd0;
por_rst <= 1'b1;
end else if (por_count != 20'hfffff) begin
por_count <= por_count + 1'b1;
por_rst <= 1'b1;
end else begin
por_rst <= 1'b0;
end
end
reg clk50mhz;
wire clk50mhz_buf;
reg[3:0] rst_sync;
wire soc_rst;
always @(posedge clk100mhz or posedge por_rst) begin
if (por_rst) begin
clk50mhz <= 1'b0;
end else begin
clk50mhz <= ~clk50mhz;
end
end
BUFG clk_buf(
.I(clk50mhz),
.O(clk50mhz_buf)
);
always @(posedge clk50mhz_buf or posedge por_rst) begin
if (por_rst) begin
rst_sync <= 4'hf;
end else begin
rst_sync <= {rst_sync[2:0], 1'b0};
end
end
assign soc_rst = rst_sync[3];
wire[31:0] debug_writedata;
wire[31:0] debug_dataadr;
wire debug_memwrite;
wire uart_tx_ready;
wire uart_rx_valid;
soc #(.UART_CLKS_PER_BIT(434)) soc(
.clk(clk50mhz_buf),
.rst(soc_rst),
.uart_rx_i(uart_rx_i),
.uart_tx_o(uart_tx_o),
.led(led),
.debug_writedata(debug_writedata),
.debug_dataadr(debug_dataadr),
.debug_memwrite(debug_memwrite),
.uart_tx_ready(uart_tx_ready),
.uart_rx_valid(uart_rx_valid)
);
endmodule