Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
2b7bddbb0This file is pinned to the selected release. Download the original to open it in your design tool.
module serv_bufreg2
(
input wire i_clk,
//State
input wire i_en,
input wire i_init,
input wire i_cnt_done,
input wire [1:0] i_lsb,
input wire i_byte_valid,
output wire o_sh_done,
output wire o_sh_done_r,
//Control
input wire i_op_b_sel,
input wire i_shift_op,
//Data
input wire i_rs2,
input wire i_imm,
output wire o_op_b,
output wire o_q,
//External
output wire [31:0] o_dat,
input wire i_load,
input wire [31:0] i_dat);
reg [31:0] dat;
assign o_op_b = i_op_b_sel ? i_rs2 : i_imm;
wire dat_en = i_shift_op | (i_en & i_byte_valid);
/* The dat register has three different use cases for store, load and
shift operations.
store : Data to be written is shifted to the correct position in dat during
init by dat_en and is presented on the data bus as o_wb_dat
load : Data from the bus gets latched into dat during i_wb_ack and is then
shifted out at the appropriate time to end up in the correct
position in rd
shift : Data is shifted in during init. After that, the six LSB are used as
a downcounter (with bit 5 initially set to 0) that triggers
o_sh_done and o_sh_done_r when they wrap around to indicate that
the requested number of shifts have been performed
*/
wire [5:0] dat_shamt = (i_shift_op & !i_init) ?
//Down counter mode
dat[5:0]-1 :
//Shift reg mode with optional clearing of bit 5
{dat[6] & !(i_shift_op & i_cnt_done),dat[5:1]};
assign o_sh_done = dat_shamt[5];
assign o_sh_done_r = dat[5];
assign o_q =
((i_lsb == 2'd3) & dat[24]) |
((i_lsb == 2'd2) & dat[16]) |
((i_lsb == 2'd1) & dat[8]) |
((i_lsb == 2'd0) & dat[0]);
assign o_dat = dat;
always @(posedge i_clk) begin
if (dat_en | i_load)
dat <= i_load ? i_dat : {o_op_b, dat[31:7], dat_shamt};
end
endmodule