Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
7f4e6f21cThis file is pinned to the selected release. Download the original to open it in your design tool.
use <catchnhole/catchnhole.scad>;
bolt = "M3";
press_fit = 0;
tight_fit = 0.1;
fit = 0.2;
v_slot_sliding_fit = 0.021; // H7/h6 over a 20 mm "shaft"
loose_fit = 0.5;
bolt_wall_min_d = 3.6;
bolt_wall_d = bolt_diameter(bolt) + bolt_wall_min_d;
bearing_wall_min_d = 5;
v_slot_wall_min_t = 4;
fastener_wall_min_h = 1.6; // Minimum thickness of a wall alongside fastener axis.
nut_wall_min_d = 4;
nut_wall_h = nut_height(bolt) + fastener_wall_min_h;
nut_wall_d = nut_width_across_corners(bolt) + nut_wall_min_d;