Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
f5e39e496This file is pinned to the selected release. Download the original to open it in your design tool.
PROJECT_NAME = $(shell basename "$(realpath ./)")
#List all of the application source files that need to be compiled
#############################################
APPLICATION_SRCS = $(notdir $(wildcard ./*.c))
APPLICATION_SRCS += led.c
APPLICATION_SRCS += timer.c
APPLICATION_SRCS += prng.c
APPLICATION_SRCS += delay.c
APPLICATION_SRCS += stm32f0xx_gpio.c
APPLICATION_SRCS += stm32f0xx_rcc.c
APPLICATION_SRCS += stm32f0xx_i2c.c
APPLICATION_SRCS += stm32f0xx_dma.c
APPLICATION_SRCS += stm32f0xx_misc.c
APPLICATION_SRCS += stm32f0xx_tim.c
APPLICATION_SRCS += stm32f0xx_spi.c
APPLICATION_SRCS += stm32f0xx_pwr.c
APPLICATION_SRCS += stm32f0xx_exti.c
APPLICATION_SRCS += stm32f0xx_syscfg.c
APPLICATION_SRCS += stm32f0xx_i2c_cpal.c
APPLICATION_SRCS += stm32f0xx_i2c_cpal_hal.c
APPLICATION_SRCS += deca_device.c
APPLICATION_SRCS += deca_params_init.c
CFLAGS += -DBOARD=TRIPOINT
LDFLAGS += -lm
#The exact STM part number All CAPS
############################################
DEVICE ?= STM32F031G6
DEVICE_FAMILY ?= STM32F031
## HACK FOR stm32f031
## Need to define this so that CPAL will compile.
## It is never used, however.
ifeq ($(DEVICE_FAMILY), STM32F031)
CFLAGS += -DI2C2_IRQn=24
endif
CFLAGS += -Wall
#The install locations of the STM Standard library
#################################################
LIBRARY_START_PATH ?= ../stm32f0-base/sdk/stm32f0xx-1.5.0/
#The location of the gcc setup template
################################################
TEMPLATE_PATH ?= ../stm32f0-base/stm32f0xx-gcc-setup/template/
#Any places that you put custom header files
###############################################
LIBRARY_PATHS += ../include ../dw1000-driver
#Any places that you put custom source files
##############################################
SOURCE_PATHS += ../source ../dw1000-driver
ifndef LIBRARY_START_PATH
$(error An LIBRARY_START_PATH must be defined. Edit Makefile to define a valid LIBRARY_PATH)
endif
# Set an ID for programming the nodes EUI
ifeq ($(ID), )
ID = c0:98:e5:50:50:44:50:FF
endif
CFLAGS += -Os
GDB_PORT_NUMBER = 2331
include $(TEMPLATE_PATH)Makefile