PawPad

PawPad programming header

This is a project that aims to spice up the world of boring test jigs and programming headers with a completely new, full stack system for adding programming headers to your boards.

Why should I use this?

There are many benefits in the above shape compared to regular arrangements:

• No acid traps due to smooth curves
• No holes in the PCB means easier routing
• Big enough to solder wires to when needed, yet compact enough to be practical
• Large surface area makes it hard to peel the pads off and easier to hit with a jig
• Pretty

Files

PawPad - contains the KiCAD footprint.

Programming Jig - contains a programming jig meant to be screwed onto a piece of 10x10 aluminium extrusion/makerbeam.

Pinout

The pinout is standardized as outlined below:

Pin	SWD	JTAG	SPI / ICSP	UART	I2C
Bean (1)	SWO	TDO	MISO	RX	-
Bean (2)	SWDIO	TDI	MOSI	TX	SDA
Bean (3)	SWCLK	TCK	SCK	-	SCL
Bean (4)	NRST	TMS	RST	RST	RST
Big Bean (5)	GND	GND	GND	GND	GND

Showcase

Did you add this to your PCBs? Let us know by opening an Issue!

Example of the Programming Jig in action on a test PCB:

Future plans

• Alternative designs with different numbers of pins
• Unified pinout standard
• OSHW certification
• Debugger design

Acknowlegments

This has been inspired by the original maker of the footprint, go check them out.