OpenRemoteID

Open hardware for a standalone broadcast Remote ID module built around an ESP32-C3-MINI-1 radio module and an ATGM336H GNSS receiver.

Status

This repository is an incomplete hardware concept, not a compliant or released product. The KiCad schematic contains six placed devices and does not pass ERC; run it for the current findings. The two-layer PCB contains the same six footprints and no routed tracks, vias or copper zones. No firmware is present.

The intended interfaces are 5 V power, ground, UART RX/TX, a GNSS antenna on U.FL, a status LED and a push button. See hardware/DESIGN.md for the boundary between checked-in design facts and design intent.

Repository

• hardware/OpenRemoteID.kicad_sch: incomplete schematic
• hardware/OpenRemoteID.kicad_pcb: incomplete two-layer placement
• hardware/lib.kicad_sym, hardware/lib.pretty/, hardware/lib.3dshapes/: project-local libraries
• hardware/datasheets/: component datasheets
• research/: market research; it is reference material, not product evidence

Regulatory position

ASTM F3411 and EN 4709-002 are design targets only. This repository contains no completed firmware, conformity assessment, declaration, radio test report or authority acceptance for this product. Certification or modular approval of a component does not by itself certify the finished product.

License

Hardware is licensed under CERN-OHL-S-2.0.