OCCT

puts "========"
puts "OCC262"
puts "========"

restore [locate_data_file OCC262.brep] a 
# checkshape a

set tolerance 1e-5

build3d a ${tolerance}

fsameparameter a

explode a E 
# Verify only a_1 and a_2 eges because a_3 had 3d curve before call of build3d command

set toler1 [maxtolerance a_1]
regexp { +Edge +: +Min +[-0-9.+eE]+ +Max +([-0-9.+eE]+)} $toler1 full MaxEdgeTolerance1

if { [ expr $MaxEdgeTolerance1 > $tolerance ] } { 
    puts "OCC262 - FAULTY. Tolerance of a_1 is too big" 
} else { 
    puts "TOLERANCE OF A_1 - OK"
}

set toler2 [maxtolerance a_2]
regexp { +Edge +: +Min +[-0-9.+eE]+ +Max +([-0-9.+eE]+)} $toler2 full MaxEdgeTolerance2

if { [ expr $MaxEdgeTolerance2 > $tolerance ] } {
    puts "OCC262 - FAULTY. Tolerance of a_1 is too big"
} else { 
    puts "TOLERANCE OF A_2 - OK" 
}


#set tolerancelist [maxtolerance a]

#set list [split ${tolerancelist} "\n\t"]
#set listLength [llength ${list}]
#if { ${listLength} < 9 } then {puts "OCC262 - Error : listLength= ${listLength}"}

#set EdgeList [lindex ${list} 5]
#set MaxEdgeTolerance [lindex [split ${EdgeList}] [expr [llength [split ${EdgeList}] ] - 2] ]

#set delta [expr abs(${MaxEdgeTolerance} - ${tolerance}) / ${tolerance} * 100]

#set maxdelta 1

#if { ${delta} > ${maxdelta} } then {puts "OCC262 - Error : delta = ${delta}"} else {
#  puts "OCC262: OK"
#}

#puts "MaxEdgeTolerance = ${MaxEdgeTolerance}"

renamevar a result

checkprops result -s 449.437
checkview -display result -2d -path ${imagedir}/${test_image}.png