lasercut

include <lasercut.scad>; 

thickness = 3.1;
nut_flat_width = 7;
x = 100;
y = 200;
z =  50;
height = 75;


module supportLeft()
{
    lasercutoutSquare(thickness=thickness, x=x, y=height,
        simple_tab_holes=[
            [MID, x*.25-thickness/2, height/2], 
            [MID, x*.75-thickness/2, height/2]
            ],
        captive_nuts=[
            [UP, x/2, height, nut_flat_width] 
            ],
        twist_holes=[
            [RIGHT, x/2, height/4, height/2]
            ]
    );   
}

module supportRight()
{
    lasercutoutSquare(thickness=thickness, x=x, y=height,
        simple_tab_holes=[
            [MID, x*.25-thickness/2, height/2], 
            [MID, x*.75-thickness/2, height/2]
            ],
            clips=[
            [UP,x/2,height]
            ],
        twist_holes=[
            [RIGHT, x/2, height/4, height/2]
            ]
    );   
}

module stut()
{
    lasercutoutSquare(thickness=thickness, x=x, y=y-thickness*6,  
        simple_tabs=[
            [UP, x*.75, y-thickness*6], [UP, x*.25, y-thickness*6],
            [DOWN, x*.75, 0], [DOWN, x*.25, 0] 
            ]
        );   
}

module beam()
{
    rotate([0,90.0])
    lasercutoutSquare(thickness=thickness, x=height/2, y=y,
        twist_connect=[
            [RIGHT,height/4,thickness*2],
            [RIGHT,height/4,y-thickness*3]
            ]
        );   
}


module box()
{
    circles_remove_a = [
        [],
        [[x/4, x/2-thickness, y/2]]
    ];
    captive_nut_holes_a = [
        [ [DOWN, x/2, 0,] ]
    ];
    clip_holes_a = [
        [ [UP, x/2, y-3*thickness] ]
    ];
    lasercutoutBox(thickness = thickness, x=x, y=y, z=z, sides=6, captive_nut_holes_a = captive_nut_holes_a, clip_holes_a = clip_holes_a, circles_remove_a=circles_remove_a );
}


translate([0,thickness*3,0]) rotate([90,0,0]) supportLeft();
translate([0,y-thickness*2,0]) rotate([90,0,0]) supportRight();
translate([0,thickness*3,height/2]) stut();
translate([x/2-thickness/2,0,height/2]) beam();
translate([0,0,height]) box();