flix

# Firmware overview

The firmware is a regular Arduino sketch, and follows the classic Arduino one-threaded design. The initialization code is in the `setup()` function, and the main loop is in the `loop()` function. The sketch includes multiple files, each responsible for a specific part of the system.

## Dataflow

<img src="img/dataflow.svg" width=800 alt="Firmware dataflow diagram">

The main loop is running at 1000 Hz. All the dataflow is happening through global variables (for simplicity):

* `t` *(double)* — current step time, *s*.
* `dt` *(float)* — time delta between the current and previous steps, *s*.
* `gyro` *(Vector)* — data from the gyroscope, *rad/s*.
* `acc` *(Vector)* — acceleration data from the accelerometer, *m/s<sup>2</sup>*.
* `rates` *(Vector)* — filtered angular rates, *rad/s*.
* `attitude` *(Quaternion)* — estimated attitude (orientation) of drone.
* `controlRoll`, `controlPitch`, ... *(float[])* — pilot's control inputs, range [-1, 1].
* `motors` *(float[])* — motor outputs, range [0, 1].

## Source files

Firmware source files are located in `flix` directory. The key files are:

* [`flix.ino`](../flix/flix.ino) — main entry point, Arduino sketch. Includes global variables definition and the main loop.
* [`imu.ino`](../flix/imu.ino) — reading data from the IMU sensor (gyroscope and accelerometer), IMU calibration.
* [`rc.ino`](../flix/rc.ino) — reading data from the RC receiver, RC calibration.
* [`estimate.ino`](../flix/estimate.ino) — drone's attitude estimation, complementary filter.
* [`control.ino`](../flix/control.ino) — drone's attitude and rates control, three-dimensional two-level cascade PID controller.
* [`motors.ino`](../flix/motors.ino) — PWM motor outputs control.

Utility files include:

* [`vector.h`](../flix/vector.h), [`quaternion.h`](../flix/quaternion.h) — project's vector and quaternion libraries implementation.
* [`pid.h`](../flix/pid.h) — generic PID controller implementation.
* [`lpf.h`](../flix/lpf.h) — generic low-pass filter implementation.

## Building

See build instructions in [build.md](build.md).