Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
76479c447This file is pinned to the selected release. Download the original to open it in your design tool.
# candleLight FD
candleLight FD is a modern, CAN-FD capable version of the
[candleLight](https://github.com/linux-automation/candleLight/) based on a STM32G0B1 microcontroller.
Out of the box it comes with a single CAN channel placed.
But footprints for a second CAN channel are available.
The candleLight FD is - like the candleLight - licensed under the CERN OHL v1.2 open hardware license.

## Where to get one
The candleLight FD is available from [Linux Automation](https://linux-automation.com)
as a SMD-assembled and functionally tested kit.
## Hardware
### Interfaces
The candleLight FD uses a USB-C (USB 2 only) connector to connect to your PC.
CAN is provided on the industry standard D-SUB9 pinout:
* CAN1:
* High: Pin 7
* Low: Pin 2
* CAN2:
* High: Pin 8
* Low: Pin 1
* Power:
* 12V: Pin 9 (can be provided via P1)
* GND: Pin 3, Pin 6
### Releases: Revision 1
[Manufacturing Data](./release/candlelightfd-S01-R01) |
[Schematic](./release/candlelightfd-S01-R01/candlelightfd-S01-R01-V01/candlelightfd-S01-R01.pdf) |
[Interactive BOM](./release/candlelightfd-S01-R01/candlelightfd-S01-R01-V01/candlelightfd-S01-R01_BOM.html)
(This is the current release.)
Release Notes:
* Initial release of the candleLight FD.
## Firmware
The firmware is based on the [candleLight_fw](https://github.com/candle-usb/candleLight_fw).
Select the board config `BOARD_candleLightFD` when building the firmware.
> **_NOTE_**: We are currently upstreaming our changes to the *candleLight_fw* repository.
> While doing so you can find our sources
> [here](https://github.com/linux-automation/candleLight_fw/tree/topic/candleLightFD).
## Programming and Debugging
Everyday programming can be done via USB.
Simply invoke `dfu-util` while the device is running.
More information on flashing can be found in the
[firmware repository](https://github.com/candle-usb/candleLight_fw#flashing).
In case the device is bricked: Short the two pins labeled *BOOT* while powering on
the device.
The CPU will start in *serial download mode*.
For debugging a single wire interface is exposed on X3.
It can be connected using a [Tag Connect TC2030-IDC-NL](https://www.tag-connect.com/product/tc2030-idc-nl)
adapter.
The pinout is derived from the CandleLight.
The pinout is:
* Pin 1: 3V3
* Pin 2: SWCLK
* Pin 3: GND
* Pin 4: SWDIO
* Pin 5: NRST
* Pin 6: (not connected)
This picture shows X3 on the device.
X3 is the connector in the lower left corner - below the USB-C connector.
