Loading files
This file is pinned to the selected release. Download the original to open it in your design tool.
# Belay Configuration reference
This document is modeled after Kalico's
[Config Reference document](https://docs.kalico.gg/Config_Reference.html)
but only contains items pertaining to Belay.
### [belay]
Belay extruder sync sensors (one may define any number of sections
with a "belay" prefix).
```
[belay my_belay]
extruder_type:
# The type of secondary extruder. Available choices are 'trad_rack'
# or 'extruder_stepper'. This parameter must be specified.
extruder_stepper_name:
# The name of the extruder_stepper being used as the secondary
# extruder. Must be specified if extruder_type is set to
# 'extruder_stepper', but should not be specified otherwise. For
# example, if the config section for the secondary extruder is
# [extruder_stepper my_extruder_stepper], this parameter's value
# would be 'my_extruder_stepper'.
#multiplier_high: 1.05
# High multiplier to set for the secondary extruder when extruding
# forward and Belay is compressed or when extruding backward and
# Belay is expanded. The default is 1.05.
#multiplier_low: 0.95
# Low multiplier to set for the secondary extruder when extruding
# forward and Belay is expanded or when extruding backward and
# Belay is compressed. The default is 0.95.
#debug_level: 0
# Controls messages sent to the console. If set to 0, no messages
# will be sent. If set to 1, multiplier resets will be reported, and
# the multiplier will be reported whenever it is set in response to
# a switch state change. If set to 2, the behavior is the same as 1
# but with an additional message whenever the multiplier is set in
# response to detecting an extrusion direction change. The default
# is 0.
```
0670df1c7This file is pinned to the selected release. Download the original to open it in your design tool.