Loading files
# Task: I2C bus pull-ups
Draw the two pull-up resistors for a 3.3 V I2C bus (4.7k each):
- `R1`: pin 1 on net `3V3`, pin 2 on net `SDA`
- `R2`: pin 1 on net `3V3`, pin 2 on net `SCL`
## Contract (same for every task)
Author a single akcli op-list JSON document:
`{"protocol_version": 1, "target_format": "kicad", "target_file": "board.kicad_sch", "ops": [...]}`.
It will be validated with `akcli ops validate` and applied to a fresh blank
sheet with `akcli draw --apply --strict-nets`. Available symbols: `Device:R`,
`Device:C`, `Device:C_Polarized`, `Device:L` (all two-pin: pin 1 / pin 2) and
power ports `GND` / `+3V3`. Coordinates are mils on a 50-mil grid, origin
top-left, +Y down; keep parts >= 400 mil apart. Use net labels on pins
(`add_net_label` with `"at": "REF.PIN"`) or `connect_and_label` for
connectivity. Scoring compares the resulting NAMED nets (exact pin
membership) against the task's ground truth — use exactly the designators,
pin assignments and net names the task specifies, and introduce no other
named nets.
2126c3284This file is pinned to the selected release. Download the original to open it in your design tool.