akcli

# altium-kicad-cli.toml — reference configuration
#
# Copy to your project root as `altium-kicad-cli.toml`. `akcli` discovers it by walking up from the
# current directory; override with `-C/--config <path>`. Paths are resolved relative to THIS file's
# directory. Unknown keys are rejected with ERROR: BAD_CONFIG.

[project]
# Designator of the MCU whose pin->net mapping `akcli pinmap` reports.
mcu_designator = "U3"

# One [[rail]] table per power rail. `akcli power` enumerates rails and sanity-checks voltages;
# `akcli check` uses rail names for net-name-based power/ground detection.
[[rail]]
name = "V3V3"
voltage = 3.3
tolerance_pct = 5

# Input file locations, resolved relative to this file's directory.
[paths]
schematic = "hardware/altium/insole/main.SchDoc"
dts       = "firmware/boards/ebyte/e73_2g4m08s1e/e73_2g4m08s1e.dts"
pinout_md = "hardware/docs/pinout.md"

# ERC waivers suppress a specific rule on a specific net, with a recorded reason. Each waiver is a
# [[erc_waiver]] table. Waived findings are downgraded to NOTE and tagged with the reason.
[[erc_waiver]]
net    = "LED1_GPIO_RD"
rule   = "driver_conflict"
reason = "LED1 shares MCP73831 open-drain STAT (P0.25) by design; FW reads it as input"